wear resistant ceramic adhesiv > ceramic tile bonding installation trowelable epoxy compound

ceramic tile bonding installation trowelable epoxy compound

BD130 economic type wear resistant ceramic tile bonding adhesive(bonding agent for ceramic installation)

Product description of BD130 economic type ceramic bonding installing trowel grade epoxy compound:
White semi-fluid two components epoxy,economic type,temperature resistant is 150 deg C,used for bonding of abrasion resistant ceramic
lining plate in general working conditons.

How to use of BD130 trowelable ceramic installation epoxy compound bonding agents:
1.Surface treatment:Grinding or sand blasting to clean up the dust,greasy dirt and rust on the surface of adherend, clean it by cleaning agent
in the end.

2.The preparation of bonding agent:Make A and B two components mix uniformly according to weight ratio A:B=1:1

3.Using bonding agents:Make well-mixed adhesive be coating on the surface of adherend uniformly.

4.Curing: It can be put into use after curing for 24 hours at room temperature 25 deg C(25C 24 hours full cured),if you could heat it up to
the temperature of 60 deg C and keep this temperature for 2 hours to do post curing,in this way,it can achieve higher comprehensive
performance(it can improve 30%)

5.The well-mixed bonding agent should be used up within the specified operation time limit.

Performance index:

BD130 economic type ceramic installation bonding agent curing features table(test condition:temperature:20-25 deg C,relative humidity: 55)
Color	Physical states	density (g/cm³)	compressive strength (Mpa) GB1041-2008	shear strength (Mpa) GB7124-2008	impact strength (J/cm²) GB6328-1999
White	semi-fluid	1.54	73	13	41

Operation time limit (min)	Curing time	working temperature （℃）	The highest temperature resistant （℃）
30-60	Room temperature:24 hours or room temperature:1 hour + 60 deg C 2 hours.	-60-120	150

Special version:
1.This parameter is for laboratory conditions,due to the actual working condition is more complex,suggest the users to do the pretest
according to actual working condition.

2.When the environment temperature is below 15 deg C,the curing time will prolong,should take proper heating measure.

3.When the environment temperature is more than 25 deg C or the mixing quantity is too large,the curing speed will expedite,should properly
shorten the operation time of coating after mixing.

Transportation storage
Sealed storage in the cool and dry place. The warranty period is 24 months. Avoid placing it upside down,knocking against and transporting
it as a non-dangerous product during transportation.

Packaging specifications:
Two-component,packed in a plastic drum,part A: 15Kg/drum,part B: 15Kg/drum, or part A:20Kg/drum part B: 20Kg/drum.

Packaging photo of BD130 economic type ceramic installation bonding agent trowel grade epoxy compound

------分隔线----------------------------